Difference between revisions of "Entering the Factory Setup Menu"
(Created page with "== Old Firmwares == (a more accurate info on firmware version is needed !) You can enter the Factory Setup Menu by sending the following key combination : KEY_INFO, KEY_FACTOR...") |
|
(No difference)
| |
Revision as of 14:52, 26 June 2012
Old Firmwares
(a more accurate info on firmware version is needed !)
You can enter the Factory Setup Menu by sending the following key combination :
KEY_INFO, KEY_FACTORY
On BD players, you can only send KEY_FACTORY by network (use 'ruSamsungCommunicator' or see http://forum.samygo.tv/viewtopic.php?f=18&t=3780)
Latest Firmwares
Since BD-E has been released, new firmwares don't include the network KEY_FACTORY code.
Both BD-D and BD-E series are impacted.
To enter the Factory Setup Menu, use the following method :
- Connect to the serial console (see Serial console)
- Enter the Top Debug Menu on the serial console (enter 20102011, then 2008999)
- Enter 12 for 'Subsystem DBG'
- Enter 6 for 'SsKeyInputDebug'
- Enter 1 for 'Key Input'
- Enter 1 for 'Process Key Input'
- Choose 0 for KEY_TYP_RC
- Enter 59, but don't press enter
- On your IR remote, press INFO
- As soon as you see the info popup, press enter on the serial console...
- Once, you have the menu, press RETURN on your IR remote
If you don't get the menu :
- message 'unavailable' on the screen : you've waited too long between the info popup and sending 59 on the serial console...
- no message : you've sent 59 too soon...
Explanations :
- Code 59 stands for KEY_FACTORY (decimal 59 = 3B hex = index for KEY_FACTORY, see Key codes)
- The delay between KEY_INFO and KEY_FACTORY is very short (around 1 second), so if you don't prepare your entry for VF_FACTORY on the serial console, you get a timeout and no setup menu...
- This procedure leaves the input routine in a bad state (VK_FACTORY not released) : you have to press a key (RETURN as mentionned above, but any key will work) on your remote to return in a normal state.
To exit the Factory Setup Menu :
- Enter 1 for 'Process Key Input' on the serial console
- Choose 0 for KEY_TYP_RC
- Enter 59; you are now in the Factory Setup Menu 'Aging' state
- Press RETURN on your IR remote
- Send 59 once more as above
- Press RETURN on your IR remote; you have completely exited the Factory Setup Menu
