Difference between revisions of "Serial console"
(Created page with "To get the serial console, use the following connections on your unit PCB. Remember that you need a TTL to RS232 adapter. See here : [[Ex-Link Cable for C/D/E Series and BD play...") |
Arcadian2002 (talk | contribs) (→Serial console for BD-E6100) |
||
| (9 intermediate revisions by 2 users not shown) | |||
| Line 2: | Line 2: | ||
Remember that you need a TTL to RS232 adapter. See here : [[Ex-Link Cable for C/D/E Series and BD players]] | Remember that you need a TTL to RS232 adapter. See here : [[Ex-Link Cable for C/D/E Series and BD players]] | ||
| + | == Serial console for BD-D6900... == | ||
| + | [[File:D6900_serial00.jpg|300px]] [[File:D6900_serial01.jpg|335px]] | ||
== Serial console for BD-D8200, BD-D8500, BD-D8900 == | == Serial console for BD-D8200, BD-D8500, BD-D8900 == | ||
| − | [[File:BD-D8X00.jpg]] | + | [[File:BD-D8X00.jpg|300px]] |
| + | == Serial console for BD-E8300, BD-E8500, BD-E8900, BD-E8909S == | ||
| − | + | [[File:BD-E8X00.jpg|200px]] | |
| − | + | == Serial console for BD-E6100 == | |
| + | [[File:CN801.jpg|300px]] [[ File:1.3.5mm jack.jpg |300px]] [[File:JKlayout.jpg|300px]] [[File:3.job done.jpg|300px]] | ||
== Guidelines for models that are not listed here == | == Guidelines for models that are not listed here == | ||
Latest revision as of 12:34, 2 March 2013
To get the serial console, use the following connections on your unit PCB.
Remember that you need a TTL to RS232 adapter. See here : Ex-Link Cable for C/D/E Series and BD players
Contents
Serial console for BD-D6900...
Serial console for BD-D8200, BD-D8500, BD-D8900
Serial console for BD-E8300, BD-E8500, BD-E8900, BD-E8909S
Serial console for BD-E6100
Guidelines for models that are not listed here
If your model is not listed here, you can try to locate the signals by yourself.
- try to locate 'dead-end' resistors (one pad is not connected to anything)
- the signals directly go to the ARM processor
- the signals level is 3.3v when the console is idle
- press INFO on the remote controller to generate traffic on the TX signal
- using an oscilloscope will ease this task
