Difference between revisions of "Serial console"
m |
Arcadian2002 (talk | contribs) (→Serial console for BD-E6100) |
||
| (8 intermediate revisions by the same user not shown) | |||
| Line 14: | Line 14: | ||
[[File:BD-E8X00.jpg|200px]] | [[File:BD-E8X00.jpg|200px]] | ||
| + | == Serial console for BD-E6100 == | ||
| + | |||
| + | [[File:CN801.jpg|300px]] [[ File:1.3.5mm jack.jpg |300px]] [[File:JKlayout.jpg|300px]] [[File:3.job done.jpg|300px]] | ||
== Guidelines for models that are not listed here == | == Guidelines for models that are not listed here == | ||
Latest revision as of 12:34, 2 March 2013
To get the serial console, use the following connections on your unit PCB.
Remember that you need a TTL to RS232 adapter. See here : Ex-Link Cable for C/D/E Series and BD players
Contents
Serial console for BD-D6900...
Serial console for BD-D8200, BD-D8500, BD-D8900
Serial console for BD-E8300, BD-E8500, BD-E8900, BD-E8909S
Serial console for BD-E6100
Guidelines for models that are not listed here
If your model is not listed here, you can try to locate the signals by yourself.
- try to locate 'dead-end' resistors (one pad is not connected to anything)
- the signals directly go to the ARM processor
- the signals level is 3.3v when the console is idle
- press INFO on the remote controller to generate traffic on the TX signal
- using an oscilloscope will ease this task
