Enable Serial Console on B series TV

Find below the steps you need to follow to enable console access to your TV via a serial cable.

The Ex-Link (serial) cable

• Solder yourself ( or buy ) an Ex-Link serial cable to connect to your Samsung TV.

See here for the Serial Cable specs. You can ignore the rest of the information posted there, as it is not applicable for the more recent Samsung devices.

Configure your TV for Debug-Mode

• Enter Service Menu ( quickly push [INFO] [MENU] [MUTE] [POWER] on your remote control )
• Change setting for your RS232C interface to "debug" ( Control -> Sub Option -> RS-232 Jack -> [ Debug | UART | Logic ] )

Debug mode at older TV's like B530 series

• Enter Service Menu
• Enter "Advanced" menu. To activate `Advanced` menu need to type '0000'
• Advanced => ADJUST => Debug mode [OFF][Debug smart][Debug runtime]

Terminal Connection Parameters

• Use following connection parameters with your terminal-client ( e.g. Kermit, Hyper Therminal or ZOC Terminal ):

Baudrate: 115200
Data bits: 8
Parity: none
Stop bits: 1
Flow Control: none

For Older models (like B530), you can try lower baudrates (like 9600 bps)

Activating the serial console

• Switch on your TV ...
  If you did everything right and everything works as expected, then you should see the boot-log on your terminal.
• Enter "debug" at the invisible prompt ... to enable your serial console.
  You should see something like below with each keystroke

[SERIAL INPUT MANAGE] 1-th ENABLE Magic serial input match!
[SERIAL INPUT MANAGE] 2-th ENABLE Magic serial input match!
[SERIAL INPUT MANAGE] 3-th ENABLE Magic serial input match!
[SERIAL INPUT MANAGE] 4-th ENABLE Magic serial input match!
[SERIAL INPUT MANAGE] 5-th ENABLE Magic serial input match!
[SERIAL INPUT MANAGE] serial input ENABLE!!!!!

• Now you need to be fast ...
  • hit CTRL-C, which stops the exeDSP binary
  • immediately after that enter ( you have ca. 3 seconds ... I suggest you cut&paste this command ):

/mtd_boot/MicomCtrl 23

This now prevents your LED/LCD to stop and you have a command prompt of the TV-Console.

Debug Menu (On CI+ Devices Too)

• When you enter '1198282' numbers twice instead of debug string, you will see TOP Debug Menu like that:

====================================
[ TOP Debug Menu]
------------------------------------
1 : SubSystem Print On/Off
2 : Platform Print Setting
3 : TD Print Setting
4 : Performance Print Setting
5 : Sdal Print Setting
6 : Sdal Trace Setting
10 : Factory Debug
11 : TD Debug
12 : SubSystem DBG
20 : Performance File Write
21 : Louvre Print Setting
22 : JavaMW Print Setting
30 : Auto Lock DBG
------------------------------------
50 : ROSE Debug
60 : MediaLink Debug
70 : Jade Debug
====================================
99 : Exit
====================================
DBG> : 

Activating the serial console from Debug Menu

• Enter TOP Debug Menu
• Than enter menu numbers 11 : TD Debug -> 0x04 : spI Debug -> 68 : Shell

will let you drop linux shell on CI devices. Is could true for CI+ devices too. This will do not kill exeDSP. So you don't needed to stop watchdog after dropping linux shell.

--Dynamic1969 16:17, 3 October 2009 (UTC)