Difference between revisions of "Boot from USB using u-boot"
| Line 3: | Line 3: | ||
Requirements: | Requirements: | ||
| − | * Serial connection | + | * Serial connection |
| − | |||
* Usb disk drive or pen drive (at least 256MB) | * Usb disk drive or pen drive (at least 256MB) | ||
| − | * TFTP | + | * TFTP daemon outside TV on some host in case using pen drive or optionaly in case disk drive |
| + | |||
| + | |||
| + | 1) Enable [http://wiki.samygo.tv/index.php?title=Enable_Serial_Console_on_non_CI%2B_Devices serial debug console]. | ||
| + | |||
| + | 2) Enter u-boot [http://wiki.samygo.tv/index.php?title=Getting_access_to_uBoot_/_bootloader bootloader] prompt shell. | ||
'''Instruction is in progress!''' | '''Instruction is in progress!''' | ||
Revision as of 10:28, 16 March 2010
Note: This instruction apply only to LExxB65x, LExxB75x, PSxxB65x TV series with CI only supported devices
Requirements:
- Serial connection
- Usb disk drive or pen drive (at least 256MB)
- TFTP daemon outside TV on some host in case using pen drive or optionaly in case disk drive
1) Enable serial debug console.
2) Enter u-boot bootloader prompt shell.
Instruction is in progress!
